SIDEWALL VENT TERMINATION KIT FOR 90% FURNACE P.V.C. FLUE PIPES
Tired of looking at those ugly white P.V.C. flue pipes coming through your house from your 90% furnace?
These kits are meant for 3" P.V.C. flue pipes but can be used with 2 1/2" or 2" P.V.C. pipe with the use of (2) 3" x 2" or 3" x 2 1/2" P.V.C. reducers which are available at places such as Lowe's, Home Depot or hardware stores. They can NOT be used with metal flue pipes. They can be used on (1) or (2) pipe system. They can NOT be used for concentric vent systems ( a pipe within a pipe ) used by some installers, these concentric vent systems usually run (2) pipes from the furnace to close to the outside wall where they go into a single larger pipe which actually is the concentric vent.
The louvered grille on the right is the flue exhaust side and the fresh air intake is on the left ( can't be seen as it pulls it's air from the rear of the oval cover ).
The approximate installed sizes are as follows. About 1" deep from the wall. The length is approximately 12.5" and the width is approximately 8".
These kits can be used with Trane, American Standard, Carrier, York, Lennox, Rheem, Rudd, Tempstar, York, Goodman and just about every other 90% furnace on the market that are approved by the equipment manufacturer for venting with P.V.C. pipe.
Condensing Gas Furnace Nordyne Side Wall
3 inch Vent Kit
NEW IN A BOX
Used with Residential Condensing Furnaces
CONTENTS:
- Vent termination base
- Vent termination cap
- Four (4) 1" long stainless screws
- Four (4) 2" long stainless screws
- No Special Fittings Required
- Instruction sheet included
Sign In
